Alpha Microsystems AM-647 Manual de instrucciones descargar pdf (Pagina 30)

Page 26 AM-64x DAT High Capacity Tape Drives

PDI-00649-00, A01

COPY AMOS32.INI=TEST.INI

RETURN

If the computer

doesn't

boot successfully, or if the DAT drive does not appear in the DEVTBL display,

press the RESET button to reboot your computer under its original initialization file. Review the changes

you made to the TEST.INI. Verify that the DAT drive is cabled correctly, and its drive ID jumpers are

set properly. Use the SCSI command to see if the drive is detected on the SCSI bus, and that no other

device is set to the same SCSI ID

WARM BOOTING

You can warm boot from your DAT drive when your system contains one of the CPU boards listed

below. However, your boot PROMs must meet the revision requirements in the applicable table:

Boot PROMS for AM-647 DAT Drives

CPU Board PROM Revision

AM-134-XX A00

AM-135-XX A00

AM-140 A00

AM-145 B02

AM-175 G02

AM-180 D02

AM-185 A01

AM-185(-50) A00

The following table applies to all AM-648 and AM-649-00 drives, and AM-649-01 drives labeled HP

model C1533A:

Boot PROMS for AM-648 and Most AM-649 DAT Drives

CPU Board PROM Revision

AM-137 K00

AM-140 * F00

AM-172 K00

AM-174 H00

AM-190 E00

* Requires AM-540 Enhancement

The following table applies only to late model AM-649-01 drive labeled as HP Model C1599A:

Boot PROMS for Later AM-649-01 DAT Drives

CPU Board PROM Revision

AM-137

M00

AM-172 M00

AM-174

N00

AM-190

F00

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 40 41

Comentarios a estos manuales

Sin comentarios

Alpha Microsystems AM-647 Manual de instrucciones Pagina 30

Comentarios a estos manuales

Relacionado con productos y manuales para Las unidades de cinta Alpha Microsystems AM-647