Alpha Microsystems AM-647 Especificaciones descargar pdf (Pagina 30)

Page 25Installation Instructions: Roadrunner 030 & 040 AM-1000 / AM-1200 Upgrade

8.Once the bracket is aligned with the nylon standoffs on the bottom of the chassis,

install the phillips-head screws that hold the assembly in place.

11.2Roadrunner Center Position Mount (No Peripheral)

To install the Roadrunner board between the power supply and the hard disk drive in a

configuration where no tape or diskette drive is being used, the Roadrunner board

mounts on four two inch long standoffs. The Roadrunner board and the standoffs are

assembled as shown in the following figure. The standoffs, as well as the nuts holding

the standoffs in place are shown below. The screws that attach the Roadrunner board

to the standoffs are standard 6-32 phillips head screws. The standoffs, screws, nuts,

and washers are included in the PDB-00172-10 installation kit.

SIMM CONNECTOR

TOWARD FRONT

PANEL

TOWARD REAR

PANEL

AM-1000/1200

CHASSIS BOTTOM

2" STANDOFFS

#6-32 NUT

6-32 PHILLIPS-HEAD

SCREW

MAC928

Roadrunner Board Center Position Mounting Assembly

PDI-00172-10, Rev. A03

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 65 66

Sin comentarios

Alpha Microsystems AM-647 Especificaciones Pagina 30