Alpha Microsystems AM-647 Especificaciones Pagina 31

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 66
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 30
Page 26 Installation Instructions: Roadrunner 030 & 040 AM-1000 / AM-1200 Upgrade
Once the standoffs are attached to the Roadrunner board, the assembly can be placed
inside the chassis between the power supply and the hard disk drive. Make sure the
Roadrunner board is oriented as shown in the prior figure; the SIMM connector on the
Roadrunner board needs to be closest to the computer’s rear panel. There are four
screw holes in the bottom of the AM-1000/1200 chassis that will align with the standoffs
on the Roadrunner board. Position the standoffs over the screw holes and secure the
assembly in place.
11.3Roadrunner Mounting Over Center Peripheral
If your computer has a half-height floppy drive or Tandberg streaming tape drive, the
PDB-00172-11 installation kit includes the necessary hardware for mounting the
Roadrunner board above the diskette or tape drive.
In order to mount the Roadrunner board above a center mounted half-height diskette or
tape drive, the drive must be mounted close enough to the chassis bottom to allow
adequate clearance for the Roadrunner board. Over the years, the length of the
standoffs used to mount a diskette or tape drive in AM-1000/1200 chassis varied. If your
diskette or tape drive is mounted on standoffs that are no longer than one inch, you can
install the Roadrunner board and its mounting brackets as shown on the following page.
If the standoffs are longer than one inch, you will need to mount the diskette or tape
drive on shorter standoffs, which are included in the installation kit. Also, you will need
to install a new front panel (included in the installation kit) as shown below.
SYSTEM RESET
STATUS
RUN LIGHT
POWER
PARITY ERROR
alpha micro
1000
MAC929
The installation kit
includes a new front panel
that positions the peripheral
closer to the chassis bottom.
Install the new front panel
DWF-20492-02.
Remove the old front panel.
New Front Panel Installation
PDI-00172-10, Rev. A03
Vista de pagina 30
1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 65 66

Comentarios a estos manuales

Sin comentarios