Alpha Microsystems AM-649 Guía de usuario descargar pdf (Pagina 19)

and hexadecimal masks.

In Summary:

To change IP address, Gateway, Subnet and DHCP name (where applicable)

use Menu 0

To change the serial settings (baud rate handshaking etc) use Menu 1

To change the Local Port, Remote IP address & Remote Port use Menu 1

To enable or disable telnet, HTTP, SNMP, TFTP & passwords use Menu 6

To restore factory default settings (except IP address/subnet/Gateway) use

Menu 7

Tip: Press ENTER to move through the menu fields without changing them.

Top-tip: Ensure you save any changes made in the above by selecting Menu 9

☺

4.4.4 Via Serial Port (master config port)

The RS232 port is always enabled and is therefore the master config port. To

access the config menus you will need to establish a serial session using a PC or

Terminal.

1. For a PC, connect as follows:

Connect NetPort to the COM

Port of the PC.

LAN01 & LAN06 variants will

require a null modem cable to

transpose the TX/Rx wires as

both the PC & LAN01 are DTE

devices. A null modem cable in

its simplest form connects the

GND (pin 5) and crosses the Tx

(pin 3) and Rx (pin 2) wires over.

LAN02 variants will connect

directly to the COM Port.

DO NOT POWER THE NETPORT YET

2. On the PC, run a Terminal Application such as HyperTerminal, MTTY or

similar. Set the Application to connect with the following settings:

PSU

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 45 46

Sin comentarios

Alpha Microsystems AM-649 Guía de usuario Pagina 19