Alpha Microsystems AM-649 Guía de usuario descargar pdf (Pagina 44)

A 0> prompt indicates that you have successfully entered Monitor Mode and looks like

this:

Monitor Mode (Telnet)

You can perform the following actions, observe upper-case where shown.

VS x.x.x.x Version

Queries software header record (16 bytes) of

unit with IP address x.x.x.x.

PI x.x.x.x Ping

Pings unit with IP address x.x.x.x to check

device status.

AT ARP Table Shows the unit’s ARP table entries.

TT TCP Connection Table

Shows all incoming and outgoing TCP

connections.

NC Network Connection

Shows the unit’s IP configuration - IP

address, Subnet Mask & Gateway where

applicable. Note: if the user has fixed these

parameters then they may not be an accurate

reflection of the real-time status on the LAN

RS Reset Resets the unit’s power.

QU Quit Exits diagnostics mode.

Note: Entering any of the commands listed above generates one of the following command

response codes:

Command Response Codes

8 Appendix C - Reloading Firmware

There are two ways to update the unit's internal operational code (*.ROM): via

DeviceInstaller (the preferred way) or via TFTP. You can also update the unit's internal Web

interface (*.COB) via TFTP or DeviceInstaller.

1 2 ... 39 40 41 42 43 44 45 46

Sin comentarios

Alpha Microsystems AM-649 Guía de usuario Pagina 44