Alpha Microsystems AM-649 Guía de usuario descargar pdf (Pagina 25)

Setup Menu Options

4. Select an option on the menu by entering the number of the option in the Your

choice? field and pressing Enter.

5. To enter a value for a parameter, type the value and press Enter, or to confirm a

current value, just press Enter.

6. When you are finished, save the new configurations (option 9). The unit reboots.

Using the Serial Port

To initially configure the unit through a serial connection:

1. Connect a console terminal or PC running a terminal emulation program to your unit's

serial port. The default serial port settings are 9600 baud, 8 bits, no parity, 1-stop bit, no-

flow control.

2. To enter Setup Mode, reset the unit by cycling the unit's power (power off and back on).

The self-test will begin. You have one second to enter three lowercase x characters

(xxx).

Note: The easiest way to enter Setup Mode is to hold down the x key at the terminal (or

emulation) while resetting the unit.

3. At this point, the screen display is the same as when you use a Telnet connection

The following figure shows all of the configuration parameters. The remainder of this Appendix

describes each parameter in detail.

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 45 46

Sin comentarios

Alpha Microsystems AM-649 Guía de usuario Pagina 25