Alpha Microsystems AM-649 Guía de usuario descargar pdf (Pagina 20)

9600bps, No parity, 8 bit data, 1 stop bit, no handshaking

3. Once the Application is running, power up the NetPort and hold down the ‘x’

key on the PC until you receive the following prompt:

Note: If the CAPS lock is enabled on your keyboard NetPort will not respond.

Turn off CAPS Lock, turn off power to NetPort and repeat the above.

4. You will need to press ENTER within 3 seconds or NetPort will time out and

close the session.

5. Once the session has begun NetPort will scroll through all of its config in an

ASCII format and then offer an ASCII menu.

See Appendix A – Setup Mode Parameters for a full breakdown of the options

and hexadecimal masks.

In Summary:

To change IP address, Gateway, Subnet and DHCP name (where applicable)

use Menu 0

To change the serial settings (baud rate handshaking etc) use Menu 1

To change the Local Port, Remote IP address & Remote Port use Menu 1

To enable or disable telnet, HTTP, SNMP, TFTP & passwords use Menu 6

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 45 46

Sin comentarios

Alpha Microsystems AM-649 Guía de usuario Pagina 20