Alpha Microsystems AM-649 Guía de usuario descargar pdf (Pagina 5)

Custom versions of NetPort

The above list is not exhaustive and customisation of NetPort to suit customer’s requirements is

available. Minimum order quantities for customisation will apply.

3 Connecting NetPort

To get started, you must connect the NetPort to your network. Follow the steps

below:

Note: This procedure assumes that the PC is connected to the network.

You may connect a crossover Ethernet cable directly between the PC and

NetPort if a network is not available but you will need to fix the IP address

of both PC & NetPort for consistent operation.

The final setup should look like this:

If powered up correctly, the NetPort power LED will light yellow and

remains on. This LED is on the RS232 end.

Verification Check 2: If the Ethernet Port on NetPort has authenticated

with the LAN successfully then the LED’s will confirm the speed and

connect mode according to the RHS section of the diagram below:

NETWORK

Ethernet Hub

or Switch

PSU

Your RS232

Equipment

Internal 3v3 Power

Yellow = ON

Network End

RS232 End

RS232 connection

Green = connected

Ethernet Link

Green=100Mb/s

Yellow=10Mb/s

Ethernet Activity (flash)

Green=Full Duplex data flow

Yellow=Half Duplex data flow

1 2 3 4 5 6 7 8 9 10 ... 45 46

Sin comentarios

Alpha Microsystems AM-649 Guía de usuario Pagina 5